Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SRS SEAT CUSHION AIRBAG ASSEMBLY (for Hatchback)

SRS SEAT CUSHION AIRBAG ASSEMBLY (for Hatchback) > REMOVAL


CAUTION:
  1. Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).
  2. Wear protective gloves. Sharp areas on the parts may injure your hands.

NOTICE:
Always use "TORX" socket wrench E10 when removing the front seat.

HINT:
The procedure described below is for the driver side. Use the same procedure for both the driver and front passenger sides, unless otherwise specified.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

HINT:
The procedure described below is for the driver side. Use the same procedure for both the driver and front passenger sides, unless otherwise specified.



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



3. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Side)
(Click here)


4. REMOVE FRONT SEAT INNER BELT ASSEMBLY RH (for Front Passenger Side)
(Click here)


5. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH


    B283227E02
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw to remove the reclining adjuster release handle.
    Text in Illustration 
    *a
    Protective Tape



6. REMOVE VERTICAL ADJUSTING HANDLE LH (w/ Vertical Adjuster)


    B283228
  1. Remove the screw and vertical adjusting handle.



7. REMOVE FRONT SEAT CUSHION SHIELD LH


    B283229
  1. Remove the screw.

  1. Disengage the 2 claws and clip to remove the front seat cushion shield.



8. REMOVE FRONT SEAT CUSHION INNER SHIELD LH


    B283230
  1. Disengage the 2 claws to remove the front seat cushion inner shield.



9. REMOVE SEAT CUSHION COVER WITH PAD


    B332511
  1. Disengage the 2 hooks.

  1. Disconnect the seatback cover band.



    B289256
  1. Unfasten the hook and loop fastener. (w/ Front Seat Side Airbag)



    B351897
  1. Disengage the 2 hooks. (for TMMF Made)



    B272761
  1. Disengage the 4 hooks.



    B290038
  1. Disengage the 3 clamps to separate the front seat airbag wire harness. (w/ Front Seat Side Airbag)



    B332533
  1. Disengage the 2 hooks.



  1. Disengage the 5 hooks to remove the seat cushion cover with pad from the separate type front seat cushion spring assembly.


    B349730



10. REMOVE SRS SEAT CUSHION AIRBAG ASSEMBLY
  1. Disengage the clamps.



    B291397
  1. Remove the 3 nuts and the SRS seat cushion airbag assembly.

    CAUTION:
    1. The nuts must not be reused.
    2. Make sure that the seat frame assembly is not deformed. If it is, replace it with a new one.