Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for Sedan)

FRONT SEAT ASSEMBLY (for Sedan) > INSTALLATION


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

NOTICE:
Always use an E10 "TORX" socket wrench when installing the front seat.

HINT:
The procedure described below is for the driver side. Use the same procedure for both the front passenger and driver sides, unless otherwise specified.



1. INSTALL FRONT SEAT ASSEMBLY (for RH Side)


B209186E01

NOTICE:
Follow the procedure described below in order to prevent the seat tracks from locking separately.

  1. Insert the 2 locating pins through the 2 body holes, place the front seat in the most forward position, and then make sure that the inner and outer seat tracks are locked securely.

  1. Using an E10 "TORX" socket wrench, tighten bolt 1 and then bolt 2 on the rear side.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }

  1. Move the front seat to the most rearward position, and then make sure that the inner and outer seat tracks are locked securely.

  1. Using an E10 "TORX" socket wrench, tighten bolt 3 and then bolt 4 on the front side.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }

    HINT:
    If the inner and outer seat tracks do not lock simultaneously, loosen the bolts and adjust the seat tracks.

  1. Connect the occupant detection ECU connector.

  1. Connect the buckle switch connector.

  1. Install the clamp.



2. INSTALL FRONT SEAT ASSEMBLY (for LH Side)


B138318E01

NOTICE:
Follow the procedure described below in order to prevent the seat tracks from locking separately.

  1. Insert the 2 locating pins through the 2 body holes, place the front seat in the most forward position, and then make sure that the inner and outer seat tracks are locked securely.

  1. Using "TORX" socket wrench E10,Using an E10 "TORX" socket wrench, tighten bolt 1 and then bolt 2 on the rear side.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }

  1. Move the front seat to the most rearward position, and then make sure that the inner and outer seat tracks are locked securely.

  1. Using an E10 "TORX" socket wrench, tighten bolt 3 and then bolt 4 on the front side.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }

    HINT:
    If the inner and outer seat tracks do not lock simultaneously, loosen the bolts and adjust the seat tracks.

  1. Connect the buckle switch connector.



3. INSTALL FRONT SEAT HEADREST ASSEMBLY
  1. Push in the lock button of the front seat headrest support and install the front seat headrest.



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



5. INSPECT SRS WARNING LIGHT
(Click here)