STEERING WHEEL (for Sedan) > INSTALLATION |
| 1. ADJUST SPIRAL CABLE |
![]() |
Center the spiral cable.
Turn the spiral cable counterclockwise until it locks.
![]() |
Turn the spiral cable 2.5 times clockwise from its locked position and align the center marks.
| 2. INSTALL STEERING WHEEL ASSEMBLY |
![]() |
Align the matchmarks and install the steering wheel assembly onto the steering column assembly.
Install the nut.
Connect all connectors to the spiral cable.
| 3. INSTALL STEERING PAD |
![]() |
Confirm that the ignition switch is turned to OFF.
Confirm that the negative battery terminal is detached.
Connect the horn terminal.
Connect the airbag connector.
![]() |
Install the steering pad.
Using "Torx" socked wrench T30, tighten the 2 bolts.
| 4. POSITION FRONT WHEELS FACING STRAIGHT AHEAD |
| 5. CHECK SRS WARNING LIGHT |