FRONT SEAT INNER BELT ASSEMBLY (for Sedan) > INSTALLATION |
| 1. INSTALL FRONT SEAT INNER BELT ASSEMBLY |
![]() |
Install the front seat inner belt with the nut.
Install the wire harness into the claw of the front seat cushion inner shield.
![]() |
for Driver Side:
Install the 2 clamps.
Install the connector.
Connect the seat position sensor connector.
![]() |
for Front Passenger Side:
Install the 2 clamps.
Install the connector.
| 2. INSTALL FRONT SEAT ASSEMBLY |
![]() |
Insert the 2 locating pins through the 2 body holes, place the front seat in the most forward position, and then make sure that the inner and outer seat tracks are locked securely.
Using "TORX" socket wrench E10,Using an E10 "TORX" socket wrench, tighten bolt 1 and then bolt 2 on the rear side.
Move the front seat to the most rearward position, and then make sure that the inner and outer seat tracks are locked securely.
Using an E10 "TORX" socket wrench, tighten bolt 3 and then bolt 4 on the front side.
Connect the buckle switch connector.
| 3. INSTALL FRONT SEAT HEADREST ASSEMBLY |
Push in the lock button of the front seat headrest support and install the front seat headrest.
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. INSPECT SRS WARNING LIGHT |