Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM (for Sedan)

THEFT DETERRENT SYSTEM (for Sedan) > Luggage Compartment Door Key Cylinder Switch Circuit


DESCRIPTION

The luggage compartment door unlock detection switch comes on when the luggage compartment door key cylinder is turned to the unlock position with the key.

WIRING DIAGRAM


B122654E03


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM (LUGGAGE COMPARTMENT DOOR UNLOCK DETECTION SWITCH)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester main switch ON.

  1. Select the item below in the Data List and read the display on the tester.

    Theft Warning ECU:

    Item
    Test Details
    Diagnostic Note
    Trunk Key Unlock
    Luggage compartment door unlock detection switch signal ON
    -

    OK:
    When the luggage compartment door is unlocked, "ON" appears on the screen.

    HINT:
    The theft warning ECU detects the luggage compartment door lock condition using signals from the luggage compartment door unlock detection switch.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

2.INSPECT LUGGAGE COMPARTMENT DOOR UNLOCK DETECTION SWITCH


    B141935E01
  1. Disconnect the J43 unlock detection switch connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    The luggage compartment door is locked
    10 kΩ or higher
    1 - 2
    The luggage compartment door is unlocked
    Below 1 Ω

  1. Reconnect the unlock detection switch connector.



NG
REPLACE LUGGAGE COMPARTMENT DOOR UNLOCK DETECTION SWITCH (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU - UNLOCK DETECTION SWITCH)


    B144487E01
  1. Disconnect the D26 theft warning ECU and the J43 unlock detection switch connectors.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    D26-6 (LUG) - J43-2
    Below 1 Ω
    D26-6 (LUG) or J43-2 - Body ground
    10 kΩ or higher

  1. Reconnect the theft warning ECU and the unlock detection switch connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (UNLOCK DETECTION SWITCH - BODY GROUND)


    B144427E01
  1. Disconnect the J43 unlock detection switch connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    J43-1 - Body ground
    Below 1 Ω

  1. Reconnect the unlock detection switch connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE THEFT WARNING ECU ASSEMBLY (Click here)