DTC B1412 Ambient Temperature Sensor Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1412 | An open or short in the thermistor assembly (ambient temperature sensor) circuit. |
|

| 1.CHECK FOR DTC (CAN COMMUNICATION SYSTEM) |
Use the Techstream to check if the CAN communication system is functioning normally.
|
| ||||
| OK | |
| 2.READ VALUE USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Combination Meter / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Ambient Temperature | Ambient temperature sensor / Min.: -40°C (-40°F) Max.: 87.5°C (189.5°F) | Actual ambient temperature is displayed | - |
|
| ||||
| OK | |
| 3.READ VALUE USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Air Conditioner / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Ambient Temp Sensor | Ambient temperature sensor / Min.: -23.3°C (-9.94°F) Max.: 65.95°C (150.71°F) | Actual ambient temperature is displayed | - |
| Result | Proceed to |
| OK (When troubleshooting according to the DTC) | A |
| OK (When troubleshooting according to Problem Symptoms Table) | B |
| NG | C |
|
| ||||
|
| ||||
| A | |
| 4.CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 5.REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY |
Temporarily replace the air conditioning amplifier assembly with a new or normally functioning one (Click here).
| NEXT | |
| 6.CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 7.INSPECT THERMISTOR ASSEMBLY (AMBIENT TEMPERATURE SENSOR) |
Inspect the thermistor assembly (ambient temperature sensor) (Click here).
|
| ||||
| OK | |
| 8.CHECK HARNESS AND CONNECTOR (THERMISTOR ASSEMBLY (AMBIENT TEMPERATURE SENSOR) - AIR CONDITIONING AMPLIFIER ASSEMBLY) |
Disconnect the A61 thermistor assembly (ambient temperature sensor) connector.
Disconnect the D100 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A61-2 - D100-35 (TX1+) | Always | Below 1 Ω |
| A61-1 - D100-34 (TX1-) | Always | Below 1 Ω |
| A61-2 - Body ground | Always | 10 kΩ or higher |
| A61-1 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||