DTC B1630/23 Rear Airbag Sensor RH Circuit Malfunction |
DTC B1632/81 Lost Communication with Rear Airbag Sensor RH |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1630/23 B1632/81 | When one of following conditions is met:
|
|

| 1.CHECK NO. 2 SIDE AIRBAG SENSOR ASSEMBLY RH |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal.
![]() |
Interchange the No. 2 side airbag sensor assembly RH with No. 2 side airbag sensor assembly LH and connect the connectors to them.
| *1 | No. 2 Side Airbag Sensor Assembly LH |
| *2 | Side Airbag Sensor RH |
Connect the cable to the negative battery terminal, and wait for at least 2 seconds.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Clear the DTCs stored in the memory (Click here).
Turn the ignition switch off.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Check for DTCs (Click here).
| Result | Proceed to |
| DTC B1630/23, B1632/81, B1635/24 and B1637/82 are not output | A |
| DTC B1635/24 or B1637/82 is output (for 5 Door) | B |
| DTC B1635/24 or B1637/82 is output (for 3 Door) | C |
| DTC B1630/23 or B1632/81 is output | D |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal.
Return the No. 2 side airbag sensor assembly LH and the No. 2 side airbag sensor assembly RH to their original positions and connect the connectors to them.
|
| ||||
|
| ||||
|
| ||||
| A | ||
| ||