DTC B1635/24 Rear Airbag Sensor LH Circuit Malfunction |
DTC B1637/82 Lost Communication with Rear Airbag Sensor LH |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1635/24 B1637/82 | When one of following conditions is met:
|
|

| 1.CHECK NO. 2 SIDE AIRBAG SENSOR ASSEMBLY LH |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal.
![]() |
Interchange the No. 2 side airbag sensor assembly LH with No. 2 side airbag sensor assembly RH and connect the connectors to them.
| *1 | No. 2 Side Airbag Sensor Assembly RH |
| *2 | Side Airbag Sensor Assembly LH |
Connect the cable to the negative battery terminal, and wait for at least 2 seconds.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Clear the DTCs stored in the memory (Click here).
Turn the ignition switch off.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Check for DTCs (Click here).
| Result | Proceed to |
| DTC B1630/23, B1632/81, B1635/24 and B1637/82 are not output | A |
| DTC B1630/23 or B1632/81 is output (for 5 Door) | B |
| DTC B1630/23 or B1632/81 is output (for 3 Door) | C |
| DTC B1635/24 or B1637/82 is output | D |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal.
Return the No. 2 side airbag sensor assembly LH and the No. 2 side airbag sensor assembly RH to their original positions and connect the connectors to them.
|
| ||||
|
| ||||
|
| ||||
| A | ||
| ||