DTC C1428 Motor Circuit Malfunction |
| DTC NO. | DTC Detection Condition | Trouble Area |
| C1428 | While the ABS motor is not operating, an open in the motor circuit continues for 2 seconds or more. |
|
| 1.CHECK HARNESS AND CONNECTOR (GND2 TERMINAL) |
Turn the ignition switch off.
Make sure that there is no looseness at the locking part and the connecting part of the connectors.
Disconnect the A15 brake actuator assembly (skid control ECU) connector.
Check the connector case and terminals for deformation and corrosion.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A15-13 (GND2) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Brake Actuator Assembly (Skid Control ECU)) |
Reconnect the A15 brake actuator assembly (skid control ECU) connector.
|
| ||||
| OK | ||
| ||