DTC C1417 High Power Supply Voltage Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1417 | The IG1 terminal voltage is 17.4 V or more for 0.8 seconds or more. |
|
| 1.INSPECT BATTERY |
Check the battery voltage.
|
| ||||
| OK | |
| 2.CHECK TERMINAL VOLTAGE (IG1 TERMINAL) |
Disconnect the skid control ECU (brake actuator assembly) connector.
Turn the ignition switch to ON.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A70-34 (IG1) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Skid control ECU) |
Turn the ignition switch off.
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Clear the DTCs (Click here).
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTC C1417 is not output | A |
| DTC C1417 is output | B |
|
| ||||
| A | ||
| ||