Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER (for Hatchback)

NOISE FILTER (for Hatchback) > REMOVAL



1. REMOVE DOOR CONTROL RECEIVER (for 5 Door)
(Click here)


2. REMOVE DOOR CONTROL RECEIVER (for 3 Door)
(Click here)


3. REMOVE RADIO SETTING CONDENSER

NOTICE:
When the terminal cover is removed, the condenser must be replaced because the terminal cover and condenser are supplied as a set.



    E222081
  1. Remove the bolt.

  1. Disengage the clamp and separate the condenser with the wire harness from the vehicle body.



    E183098E02
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the terminal cover with the wire harness from the condenser.
    Text in Illustration 
    *1
    Protective Tape



  1. Using a screwdriver, bend back and break off the claw as shown in the illustration.


    E183100

  1. Remove the terminal cover from the wire harness.