Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM (for Hatchback)

CRUISE CONTROL SYSTEM (for Hatchback) > Cruise SET Indicator Light Circuit


DESCRIPTION

When the ECM detects a cruise control main switch "on" signal from the cruise control main switch, it sends it to the combination meter through CAN communication. Then the cruise control SET indicator light turns on.

INSPECTION PROCEDURE

NOTICE:
First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication malfunctions before troubleshooting this problem.

1.PERFORM ACTIVE TEST USING TECHSTREAM (CRUISE CONTROL SET INDICATOR LIGHT)
  1. Using the Techstream, perform the Active Test (Click here).

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Indicat. SET
    Cruise control SET indicator light
    OFF/ON
    Vehicle is stopped and engine is idling

    OK:
    Indicator light turns on/off.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK


2.READ VALUE USING TECHSTREAM (CRUISE CONTROL MAIN SWITCH)
  1. Using the Techstream, read the Data List (Click here).

    Cruise Control 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Cruise Control
    Cruise Control / OFF or ON
    OFF: Cruise Control unset
    ON: Cruise Control set
    -

    OK:
    The display is as specified in the normal condition column.



NG
REPLACE ECM (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)