Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM
RM30M0E _59 Vehicle Exterior _017121 WINDOW / GLASS _0086434 POWER WINDOW CONTROL SYSTEM J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  Jam Protection Function does not Operate  


DESCRIPTION

The jam protection function operates within a specified range during the manual up or auto up operation.

HINT:

This symptom may occur only in the driver side window.


CAUTION / NOTICE / HINT

NOTICE:
·

When the front power window regulator motor assembly (driver side) is reinstalled or replaced, the power window control system must be initialized.

·

Replacing the door glass or door glass run may cause a difference to exist between the current door glass position and the position memorized in the ECU. In this case, the jam protection function may work improperly. Return the system to the pre-initialized condition and reinitialize the system.

1.

Disconnect the power window regulator motor connector during power window operation. This will return the motor to the pre-initialized condition.

HINT:

The auto up function will not work unless initialization is completed.





PROCEDURE

1.PERFORM INITIALIZATION (for DRIVER SIDE)
a.

Initialize the front power window regulator motor assembly (driver side).

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION


Result:
Proceed to
NEXT



NEXT

2.CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION)
2.CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION)
a.

Check if the driver side power window auto up and down function operates normally

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK

OK:

Auto up and down function is normal.



Result:
Proceed to
OK
NG



OK

3.CHECK JAM PROTECTION FUNCTION OPERATING RANGE

NG

GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table)

3.CHECK JAM PROTECTION FUNCTION OPERATING RANGE
a.

Check if the jam protection function operates normally for the driver side power window.

HINT:

The jam protection function will not operate within 4 mm (0.157 in.) of the fully closed position.


OK:

Jam protection function operates normally.



Result:
Proceed to
OK
NG



OK

END (PROBLEM DUE TO INITIALIZATION FAILURE)

NG

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH OR RH