Home › Suspension › TIRE / WHEEL › TIRE AND WHEEL SYSTEM › 2013.08–2017.10
RM30M0E _53 Suspension _017097 TIRE / WHEEL _0090107 TIRE AND WHEEL SYSTEM G

TIRE / WHEEL  TIRE AND WHEEL SYSTEM  INSPECTION  


PROCEDURE

Hide 1.INSPECT TIRES

a.

Check the tires for wear and proper inflation pressure.

Cold Tire Inflation Pressure:
Tire Size Front
kPa (kgf/cm2, psi)
Rear
kPa (kgf/cm2, psi)
175/65R14 82T 230 (2.3, 33) 210 (2.1, 30)
185/60R15 84H 220 (2.2, 32)



b.
C164558

Using a dial indicator, check the runout of the tires.

Maximum Tire Runout:
Vertical 1.4 mm (0.0551 in.) or less
Lateral 1.4 mm (0.0551 in.) or less



Hide 2. ROTATE TIRES

a.
C287585C01
1.417,1.521 1.542,1.677 0.125,0.156 8 false -
V100135

Front of the Vehicle


Rotate the tires as shown in the illustration.

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)


Hide 3.INSPECT AND ADJUST WHEEL BALANCE

a.

Inspect and adjust the off-the-car balance.

i.
C144019

Steel wheel:

Maximum imbalance:

8.0 g (0.0176 lb.)



ii.
C286974E01
2.083,3.688 2.542,3.885 0.458,0.198 10 false (A)

Others (Non-steel wheel):

Maximum imbalance:

8.0 g (0.0176 lb.)


NOTICE:
·

Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.

·

Do not touch the sticking surface of the tape.

·

Adhere a sticking type balance weight to the flat surface (A) shown in the illustration.

Width (A):

25 mm (0.984 in.)


·

Push the balance weight firmly to adhere it to the position.

·

Do not reuse the balance weight.

·

Use the TOYOTA genuine sticking type balance weights.



HINT:

The inner side balance weight should be installed by clipping it to the rim.