Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB(for Rear Drum Brake) › 2013.08–2017.10
RM30M0E _52 Drivetrain _017093 AXLE AND DIFFERENTIAL _0090092 REAR AXLE HUB(for Rear Drum Brake) G

AXLE AND DIFFERENTIAL  REAR AXLE HUB(for Rear Drum Brake)  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 42403 2.REMOVE REAR BRAKE DRUM SUB-ASSEMBLY

Hide 3.INSPECT REAR AXLE HUB BEARING LOOSENESS

a.
C283826

Using a dial indicator, check for looseness near the center of the rear axle hub and bearing assembly.

Maximum looseness:

0.05 mm (0.00197 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Keep the magnet of the dial indicator away from the rear speed sensor (w/ ABS).



If the looseness is more than the maximum, replace the rear axle hub and bearing assembly.


Hide 4.INSPECT REAR AXLE HUB RUNOUT

a.
C283827

Using a dial indicator, check for runout on the surface of the rear axle hub and bearing assembly outside the rear axle hub bolt.

Maximum runout:

0.07 mm (0.00276 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Make sure to set the tip of the dial indicator towards the outside of the rear axle hub bolts.

·

Keep the magnet of the dial indicator away from the rear speed sensor (w/ ABS).



If the runout is more than the maximum, replace the rear axle hub and bearing assembly.


Hide 42403 5.INSTALL REAR BRAKE DRUM SUB-ASSEMBLY

Hide 6.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 7.INSPECT AND ADJUST PARKING BRAKE LEVER TRAVEL