Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › 2013.08–2016.04
RM30M0E _54 Brake _017098 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0090184 ANTI-LOCK BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  C1271  Low Output Signal of Front Speed Sensor RH (Test Mode DTC)  C1272  Low Output Signal of Front Speed Sensor LH (Test Mode DTC)  C1401  Front Speed Sensor RH Malfunction  C1402  Front Speed Sensor LH Malfunction  


DESCRIPTION

The speed sensor detects wheel speed and sends the appropriate signals to the skid control ECU (brake actuator assembly). These signals are used for ABS control.

Speed sensor rotors have rows of alternating N and S magnetic poles, and their magnetic fields change when the rotors turn.

Each speed sensor detects that magnetic change and sends a pulse signal to the skid control ECU (brake actuator assembly).

HINT:

When the connectors between the speed sensor and skid control ECU (brake actuator assembly) are connected, the following waveform is output.


C280113C05
1.896,1.021 2.313,1.021 false 2.427,2.031 2.844,2.031 true 2.375,0.958 2.688,1.115 0.313,0.156 10 false *1 2.885,1.948 3.198,2.104 0.313,0.156 10 false *2 3.719,0.375 4.031,0.531 0.313,0.156 10 false *a 4.458,2.052 4.771,2.208 0.313,0.156 10 false *b 5.5,2.01 5.813,2.167 0.313,0.156 10 false *c 6.313,1.344 6.688,1.542 0.375,0.198 10 false 1.4 V 6.313,1.688 6.688,1.885 0.375,0.198 10 false 0.7 V
*1 Speed Sensor *2 Speed Sensor Rotor
*a Waveform (Reference):
Between Speed Sensor (-) and Body Ground
*b Low speed
*c High speed - -


DTC No. Detection Item DTC Detection Condition Trouble Area
C1271 Low Output Signal of Front Speed Sensor RH (Test Mode DTC) Detected only during Test Mode. Front speed sensor and speed sensor rotor RH (Front axle hub sub-assembly RH)
C1272 Low Output Signal of Front Speed Sensor LH (Test Mode DTC) Detected only during Test Mode. Front speed sensor and speed sensor rotor LH (Front axle hub sub-assembly LH)
C1401 Front Speed Sensor RH Malfunction Any of the following is detected:
1.

At a vehicle speed of 10 km/h (6 mph) or more, output voltage from one of the speed sensors is less than that from the other sensors for 15 seconds or more.

2.

At a vehicle speed less than 10 km/h (6 mph), output from one of the speed sensors is 0 km/h (0 mph) for 1 second or more.

3.

At a vehicle speed of 10 km/h (6 mph) or more, outputs from both speed sensors are 0 km/h (0 mph) for 15 seconds or more. (except both rear speed sensors are 0 km/h (0 mph))


Front speed sensor and speed sensor rotor RH (Front axle hub sub-assembly RH)
C1402 Front Speed Sensor LH Malfunction Any of the following is detected:
1.

At a vehicle speed of 10 km/h (6 mph) or more, output voltage from one of the speed sensors is less than that from the other sensors for 15 seconds or more.

2.

At a vehicle speed less than 10 km/h (6 mph), output from one of the speed sensors is 0 km/h (0 mph) for 1 second or more.

3.

At a vehicle speed of 10 km/h (6 mph) or more, outputs from both speed sensors are 0 km/h (0 mph) for 15 seconds or more. (except both rear speed sensors are 0 km/h (0 mph))


Front speed sensor and speed sensor rotor LH (Front axle hub sub-assembly LH)

HINT:
·

DTC C1401 and C1271 are for the front speed sensor RH.

·

DTC C1402 and C1272 are for the front speed sensor LH.



WIRING DIAGRAM

C280116E04
1.302,1.448 1.583,1.604 0.281,0.156 10 false A13 1.333,3.021 1.615,3.177 0.281,0.156 10 false A14 1.302,1.594 2.771,1.771 1.469,0.177 10 false Front Speed Sensor LH 1.323,3.188 2.792,3.365 1.469,0.177 10 false Front Speed Sensor RH 2.115,0.656 2.448,0.833 0.333,0.177 10 false FL+ 2.146,1.125 2.427,1.292 0.281,0.167 10 false FL- 5.365,1.156 5.646,1.323 0.281,0.167 10 false FL- 5.365,2.708 5.646,2.875 0.281,0.167 10 false FR- 2.135,2.688 2.417,2.854 0.281,0.167 10 false FR- 5.354,0.656 5.677,0.833 0.323,0.177 10 false FL+ 5.354,2.229 5.719,2.396 0.365,0.167 10 false FR+ 2.115,2.219 2.542,2.385 0.427,0.167 10 false FR+ 2.458,0.521 2.615,0.719 0.156,0.198 10 false 2 2.469,1.01 2.625,1.208 0.156,0.198 10 false 1 5.073,0.542 5.354,0.74 0.281,0.198 10 false 19 5.073,1.021 5.333,1.208 0.26,0.188 10 false 18 5.104,2.083 5.25,2.25 0.146,0.167 10 false 7 5.104,2.604 5.25,2.771 0.146,0.167 10 false 6 2.469,2.583 2.615,2.75 0.146,0.167 10 false 1 2.458,2.104 2.604,2.271 0.146,0.167 10 false 2 4.344,3.094 4.677,3.25 0.333,0.156 10 false A35 4.323,3.281 7.104,3.469 2.781,0.188 10 false Skid Control ECU (Brake Actuator Assembly)

PROCEDURE

1.READ VALUE USING GTS (FRONT SPEED SENSOR)
a.

Connect the GTS to the DLC3.


b.

Start the engine.


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / ABS/VSC/TRC / Data List.


e.

According to the display on the GTS, read the Data List.

Chassis > ABS/VSC/TRC > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
FR Wheel Speed FR wheel speed sensor reading Min.: 0 km/h (0 mph)
Max.: 326 km/h (202 mph)
0 km/h: Vehicle stopped When driving at constant speed:
No large fluctuations
FL Wheel Speed FL wheel speed sensor reading Min.: 0 km/h (0 mph)
Max.: 326 km/h (202 mph)
0 km/h: Vehicle stopped When driving at constant speed:
No large fluctuations
Chassis > ABS/VSC/TRC > Data List
Tester Display
FR Wheel Speed
FL Wheel Speed
50003 105 1,2

f.

Check that there is no difference between the speed value output from the speed sensor displayed on the GTS and the speed value displayed on the speedometer when driving the vehicle.

HINT:

Factors that affect the indicated vehicle speed include tire size, tire inflation, and tire wear. The speed indicated on the speedometer has an allowable margin of error. This can be tested using a speedometer tester (calibrated chassis dynamometer). For details about testing and the margin of error, see the reference chart.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>ON-VEHICLE INSPECTION


OK:

The speed value output from the speed sensor displayed on the GTS is the same as the actual vehicle speed measured using a speedometer tester (calibrated chassis dynamometer).


NOTICE:

Check the speed sensor signal after replacement.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>TEST MODE PROCEDURE


HINT:
·

The front speed sensor rotor is incorporated into the front axle hub sub-assembly. If the front speed sensor rotor needs to be replaced, replace it together with the front axle hub sub-assembly with front speed sensor.

·

If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>PROBLEM SYMPTOMS TABLE




Result:
Proceed to
OK
NG



OK

NG

REPLACE FRONT AXLE HUB SUB-ASSEMBLY