Home › Drivetrain › U340E AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION WIRE › 2013.08–2016.10
RM30M0E _52 Drivetrain _017087 U340E AUTOMATIC TRANSMISSION / TRANSAXLE _0090607 TRANSMISSION WIRE A

U340E AUTOMATIC TRANSMISSION / TRANSAXLE  TRANSMISSION WIRE  INSTALLATION  


PROCEDURE

Hide 82125J 1.INSTALL TRANSMISSION WIRE

a.

Apply a light coat of Toyota Genuine ATF WS to a new O-ring and install it to the transmission wire.

NOTICE:

Do not twist the O-ring.



b.
C282388

Pass the transmission wire through the automatic transaxle case sub-assembly.


c.

Install the transmission wire with the bolt.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE:

Make sure that the O-ring is not damaged or does not jump out of position during installation.



d.

Connect the connector to the transmission wire.


Hide 35410 2.INSTALL TRANSMISSION VALVE BODY ASSEMBLY

Hide 17801 4.INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 17735 5.INSTALL AIR CLEANER CAP WITH NO. 1 AIR CLEANER HOSE

Hide 23820 7.CONNECT FUEL VAPOR FEED HOSE ASSEMBLY

Hide 23827A 8.CONNECT NO. 2 FUEL VAPOR FEED HOSE