33829
1.INSTALL NO. 1 TRANSMISSION CONTROL CABLE SUPPORT
Perform this procedure only when replacement of the No. 1 transmission control cable support is necessary.
| *a | Arrow Mark |
| *b | Detent |
Install the No. 1 transmission control cable support to the body with the nut.
Install the No. 1 transmission control cable support so that its arrow mark points to the front of the vehicle.
Make sure that the detent of the No. 1 transmission control cable support is pushing against the dash silencer.
33820B
2.INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
To prevent damage to the transmission control cable assembly and transmission floor shift assembly, connect the automatic transaxle assembly side of the transmission control cable assembly before connecting the transmission floor shift assembly side.
Install the transmission control cable assembly to the body with the 3 nuts.
Install the transmission control cable assembly to the transmission control cable support.
| *a | P Position |
| *b | N Position |
Rotate the transmission control shaft lever counterclockwise until it stops, and then from that position rotate it clockwise by 2 notches to set it to the N position.
| *a | Paint Mark |
Install the transmission control cable assembly to the No. 1 transmission control cable bracket with a new clip.
Make sure that the paint mark on the transmission control cable assembly is aligned with the slit in the No. 1 transmission control cable bracket before installing the clip.
Connect the transmission control cable assembly to the transmission control shaft lever with the nut.
| *1 | Nut |
| *2 | Lock |
|
Rotate approximately 180° |
|
Push in |
Rotate the nut of the transmission control cable assembly approximately 180° in the direction shown in the illustration, and while holding the nut, push in the lock.
Rotating the nut too much will damage the internal spring, and the transmission control cable assembly will not be reusable. Do not turn the nut too far.
| *1 | Lock |
| *a | Protrusion |
|
Push in |
Install the transmission control cable assembly to the transmission floor shift assembly.
Install the transmission control cable assembly with the protrusion facing upwards.
After installation, make sure that the lock is projecting from A as shown in the illustration.
Make sure that the transmission control cable assembly is securely locked.
Confirm that the shift lever is in N, and then connect the end of the transmission control cable assembly to the transmission floor shift assembly.
Securely install the end of the transmission control cable assembly to the transmission floor shift assembly.
Install the end of the transmission control cable assembly so that its adjustment lock section is on the driver side.
3.ADJUST SHIFT LEVER POSITION
58151
4.INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR
Install the front No. 1 floor heat insulator to the body with the 2 bolts and nut.
17410
5.INSTALL FRONT EXHAUST PIPE ASSEMBLY
57533B
6.INSTALL FRONT FLOOR CENTER BRACE
51442C
7.INSTALL ENGINE UNDER COVER LH (w/o Metal Type Under Cover)
51405A
8.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)
51451A
9.INSTALL CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)
58910C
10.INSTALL REAR CONSOLE BOX ASSEMBLY
11.INSPECT SHIFT LEVER POSITION
12.INSPECT FOR EXHAUST GAS LEAK