Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › IMMOBILISER SYSTEM(w/o Smart Entry and Start System) › 2013.08–2014.03
RM30M0E _58 Vehicle Interior _017111 THEFT DETERRENT / KEYLESS ENTRY _0090852 IMMOBILISER SYSTEM(w/o Smart Entry and Start System) S

THEFT DETERRENT / KEYLESS ENTRY  IMMOBILISER SYSTEM(w/o Smart Entry and Start System)  DIAGNOSTIC TROUBLE CODE CHART  


Immobiliser System (w/o Smart Entry and Start System)
DTC No. Detection Item Note Link
B2784 Antenna Coil Open / Short
DTC Output Confirmation Operation:

Insert the key into the ignition key cylinder, and the ignition switch is turned on.


Click here
B2793 Transponder Chip Malfunction
DTC Output Confirmation Operation:

Insert the key into the ignition key cylinder, and the ignition switch is turned on.


Click here
B2794 Unmatched Encryption Code
DTC Output Confirmation Operation:

Insert the key into the ignition key cylinder, and the ignition switch is turned on.


Click here
B2795 Unmatched Key Code
DTC Output Confirmation Operation:

Insert the key into the ignition key cylinder, and the ignition switch is turned on.


Click here
B2796 No Communication in Immobiliser System
DTC Output Confirmation Operation:

Insert the key into the ignition key cylinder, and the ignition switch is turned on.


Click here
B2797 Communication Malfunction No. 1
DTC Output Confirmation Operation:

Insert the key into the ignition key cylinder, and the ignition switch is turned on.


Click here
B2798 Communication Malfunction No. 2
DTC Output Confirmation Operation:

Insert the key into the ignition key cylinder, and the ignition switch is turned on.


Click here
B2799 Engine Immobiliser System Malfunction Either condition is met:
·

Within 10 seconds of an engine start operation being performed (with the clutch pedal depressed*1, turn the ignition switch to ON). If there is a malfunction, the engine stops (communication begins within 3 seconds of the engine start operation being performed, and DTCs are stored after 6 seconds).

·

10 seconds after the ignition switch is turned to ON after reconnecting the cable to the negative (-) battery terminal (communication begins within 3 seconds of the ignition switch being turned to ON, and DTCs are stored after 6 seconds).


Click here
B279A Theft Deterrent System Communication Line High Fixation
DTC Output Confirmation Operation:

Turn the ignition switch to ON and wait 6 seconds.


Click here
B279C Theft Deterrent System Presence Detection
DTC Output Confirmation Operation:

Check for DTCs.


Click here