Home › Drivetrain › C50 MANUAL TRANSMISSION / TRANSAXLE › BACK-UP LIGHT SWITCH(for 1NZ-FE) › 2013.08–2016.07
RM30M0E _52 Drivetrain _017090 C50 MANUAL TRANSMISSION / TRANSAXLE _0091171 BACK-UP LIGHT SWITCH(for 1NZ-FE) A

C50 MANUAL TRANSMISSION / TRANSAXLE  BACK-UP LIGHT SWITCH(for 1NZ-FE)  INSTALLATION  


PROCEDURE

Hide 84210 1.INSTALL BACK-UP LIGHT SWITCH ASSEMBLY

a.
C290020N01
1.115,0.323 2.042,0.771 true 0.813,0.229 1.271,0.427 0.458,0.198 10 false SST

Using SST, install a new gasket and back-up light switch assembly to the manual transaxle assembly.

SST
09817-16011  

Torque:
40.2 N*m (410 kgf*cm, 30 ft.*lbf)


b.

Engage the 2 clamps and install the wire harness of the back-up light switch assembly to the manual transaxle assembly.


c.

Connect the connector to the back-up light switch assembly.


Hide 33820B 2.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

a.
C283114C01
2.552,0.708 2.99,0.646 true 3.021,0.552 3.229,0.75 0.208,0.198 10 false *a 2.052,1.594 2.208,1.792 0.156,0.198 10 true A 2.771,1.073 2.927,1.271 0.156,0.198 10 true B
*a Paint Mark


Install the transmission control cable assembly to the control cable bracket with a new clip B.

NOTICE:

Make sure that the paint mark on the transmission control cable assembly is aligned with the slit in the floor shift control lever housing support bracket before installing the clip.



b.

Connect the transmission control cable assembly to the floor shift selecting bellcrank assembly with the washer and clip A.


Hide 74410 3.INSTALL BATTERY CARRIER ASSEMBLY

Hide 6.INSPECT FOR MANUAL TRANSAXLE OIL LEAK