Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017071 1NZ-FE ENGINE CONTROL _0091213 ENGINE COOLANT TEMPERATURE SENSOR A

1NZ-FE ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  REMOVAL  


PROCEDURE

Hide 11212 2.REMOVE NO. 2 CYLINDER HEAD COVER

Hide 89422 4.REMOVE ENGINE COOLANT TEMPERATURE SENSOR

A171166

a.

Disconnect the engine coolant temperature sensor connector.


b.
A171167

Using a 19 mm deep socket wrench, remove the engine coolant temperature sensor and gasket from the cylinder head sub-assembly.

NOTICE:

If a component has been dropped or subjected to a strong impact, replace the engine coolant temperature sensor.