Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › CAMSHAFT POSITION SENSOR › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017072 2NZ-FE ENGINE CONTROL _0091223 CAMSHAFT POSITION SENSOR A

2NZ-FE ENGINE CONTROL  CAMSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11101E 1.INSTALL CAMSHAFT POSITION SENSOR

a.

Apply a light coat of engine oil to the O-ring.

NOTICE:

If reusing the camshaft position sensor, be sure to inspect the O-ring.



b.

Install the camshaft position sensor to the cylinder head sub-assembly with the bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)

NOTICE:
·

If a component has been dropped or subjected to a strong impact, replace the camshaft position sensor.

·

Make sure that the O-ring is not damaged or does not jump out of position during installation.




c.

Connect the camshaft position sensor connector.