CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY AND BODY COMPUTER
Remove the body computer from the driver side junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
| *1 | Driver Side Junction Block Assembly | - | - |
| *1 | Body Computer | - | - |
Measure the voltage and resistance according to the value(s) in the table below.
Measure the values on the wire harness side with the connectors disconnected.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| MB-1 (GND) - Body ground | - | Ground | Always | Below 1 Ω |
| MB-6 (BECU) - Body ground | - | Battery power supply | Always | 11 to 14 V |
| MB-7 (IG) - Body ground | - | Ignition switch power supply | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V |
If the result is not as specified, there may be a malfunction in the wire harness.
Install the body computer to the driver side junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>INSTALLATION
Measure the voltage and check for pulses according to the value(s) in the table below.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| 2J-3 (ACT+) - Body ground | GR - Body ground | Door lock motor lock drive output (front door) | Door control switch (power window regulator master switch assembly) or driver door key cylinder off | Below 1 V |
| Door control switch (power window regulator master switch assembly) or driver door key cylinder locked | 11 to 14 V | |||
| 2J-4 (ACT-) - Body ground | V - Body ground | Door lock motor unlock drive output (all door) | Door control switch (power window regulator master switch assembly) or driver door key cylinder off | Below 1 V |
| Door control switch (power window regulator master switch assembly) or driver door key cylinder unlocked | 11 to 14 V | |||
| 2O-2 (ACT+) - Body ground | BE - Body ground | Door lock motor lock drive output (rear door) | Door control switch (power window regulator master switch assembly) or driver door key cylinder off | Below 1 V |
| Door control switch (power window regulator master switch assembly) or driver door key cylinder locked | 11 to 14 V | |||
| 2N-1 (DCTY) - Body ground | BR - Body ground | Front door courtesy light switch LH input*1 | Front door LH open | Below 1 V |
| Front door LH closed | Pulse generation | |||
| Front door courtesy light switch RH input*2 | Front door RH open | Below 1 V | ||
| Front door RH closed | Pulse generation | |||
| F52-14 (PCTY) - Body ground | LG - Body ground | Except front door courtesy light switch LH input*1 | Except front door LH open | Below 1 V |
| Except front door LH closed | Pulse generation | |||
| Except front door courtesy light switch RH input*2 | Except front door RH open | Below 1 V | ||
| Except front door RH closed | Pulse generation | |||
| F52-19 (L1) - Body ground | W - Body ground | Door control switch input | Door control switch locked | Below 1 V |
| Door control switch off | Pulse generation | |||
| F52-12 (UL1) - Body ground | R - Body ground | Door control switch input | Door control switch unlocked | Below 1 V |
| Door control switch off | Pulse generation | |||
| F52-18 (L2) - Body ground | V - Body ground | Driver door key-linked lock input | Driver door key cylinder turned to lock position | Below 1 V |
| Driver door key cylinder off | Pulse generation | |||
| F52-11 (UL2) - Body ground | BE - Body ground*1
L - Body ground*2 |
Driver door key-linked unlock input | Driver door key cylinder turned to unlock position | Below 1 V |
| Driver door key cylinder off | Pulse generation | |||
| F52-15 (LSWD) - Body ground | L - Body ground*1 | Front door LH unlock detection switch input | Front door LH unlocked | Below 1 V |
| Front door LH locked | Pulse generation | |||
| W - Body ground*2 | Front door RH unlock detection switch input | Front door RH unlocked | Below 1 V | |
| Front door RH locked | Pulse generation | |||
| F52-8 (KSW) - Body ground*3 | SB - Body ground | Unlock warning switch input | No key in ignition key cylinder | Pulse generation |
| Key in ignition key cylinder | Below 1 V | |||
| 2N-2 (DBKL) - Body ground | R - Body ground | Front seat inner belt assembly LH signal*1 | Ignition switch ON
Front seat belt is unfastened |
Below 1 V |
| Ignition switch ON
Front seat belt is fastened |
Pulse generation | |||
| Front seat inner belt assembly RH signal*2 | Ignition switch ON
Front seat belt is unfastened |
Below 1 V | ||
| Ignition switch ON
Front seat belt is fastened |
Pulse generation |
*1: for LHD
*2: for RHD
*3: w/o Smart Entry and Start System
If the result is not as specified, the body computer or driver side junction block assembly may be malfunctioning.