Be sure that the ignition switch is off if you work near the electric cooling fans or radiator grille. With the ignition switch ON, the electric cooling fans may automatically start to run if the engine coolant temperature is high and/or the air conditioning is on.
1.DRAIN ENGINE COOLANT
89173
2.REMOVE FRONT AIRBAG SENSOR (w/ Airbag System)
23820
3.DISCONNECT FUEL VAPOR FEED HOSE ASSEMBLY
23827A
4.DISCONNECT NO. 2 FUEL VAPOR FEED HOSE
17341T
5.DISCONNECT NO. 1 AIR HOSE (for Automatic Transaxle)
17735
6.REMOVE AIR CLEANER CAP WITH NO. 1 AIR CLEANER HOSE
17801
7.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY (for Automatic Transaxle)
17801
8.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY (for Manual Transaxle)
17701
9.REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for Automatic Transaxle)
17701
10.REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for Manual Transaxle)
11.DISCONNECT RADIATOR RESERVOIR TANK HOSE
16573B
12.DISCONNECT NO. 3 RADIATOR HOSE (w/o Fan Shroud Ventilation Duct)
13.REMOVE NO. 3 RADIATOR HOSE (w/ Fan Shroud Ventilation Duct)
Loosen the 2 hose clips and remove the No. 3 radiator hose from the radiator assembly and water filler sub-assembly.
16711
14.REMOVE FAN SHROUD
Disconnect the cooling fan motor connector.
Disengage the 3 clamps to disconnect the wire harness from the fan shroud.
Disengage the 2 claws and 2 guides to remove the fan shroud from the radiator assembly.
Do not apply any excessive force to the radiator assembly when removing the fan shroud.
16361
15.REMOVE FAN
Remove the nut and fan from the cooling fan motor.
16363
16.REMOVE COOLING FAN MOTOR
Remove the 3 screws and cooling fan motor from the fan shroud.