73480
1.INSPECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH
| *a | Unlock |
| *b | Lock |
Check the angle of inclination required to lock the retractor.
Gently incline the retractor from its initial position. Check that the belt does not lock when the retractor is inclined 15° or less in any direction. Also, check that the belt locks when the inclination of the retractor is 45° or more.
Do not disassemble the retractor.
If the operation is not as specified, replace the rear seat inner with center belt assembly LH.
73480
2.INSTALL REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH
Engage the guide to install the rear seat inner with center belt assembly LH.
Install the bolt.
Check if the ELR locks.
The check should be performed with the rear seat inner with center belt assembly LH installed.
With the belt assembly installed, check that the belt locks when it is pulled out quickly.
64274
3.INSTALL NO. 1 ROOM PARTITION TRIM PAD (for Separate Seat Type)
64330D
4.INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY
62472A
5.INSTALL ROOF SIDE INNER GARNISH LH
62471A
6.INSTALL ROOF SIDE INNER GARNISH RH
Use the same procedure as for the LH side.
62552F
7.INSTALL REAR SEAT SIDE GARNISH LH
62551F
8.INSTALL REAR SEAT SIDE GARNISH RH
Use the same procedure as for the LH side.
73370
9.CONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH
73360
10.CONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY RH
Use the same procedure as for the LH side.
62332A
11.CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH
Connect the rear door opening trim weatherstrip LH.
62331A
12.CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH
Use the same procedure as for the LH side.
13.INSTALL REAR SEAT ASSEMBLY (for Fixed Seat Type)
14.INSTALL REAR SEAT ASSEMBLY (for Separate Seat Type)
81570
15.INSTALL CENTER STOP LIGHT ASSEMBLY