Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER(for RHD) › 2013.08–2017.10
RM30M0E _54 Brake _017099 BRAKE SYSTEM (OTHER) _0092764 BRAKE MASTER CYLINDER(for RHD) A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(for RHD)  INSTALLATION  


PROCEDURE

Hide 47201 1.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY

a.

Install a new O-ring to the brake master cylinder sub-assembly.


b.

Install the brake master cylinder sub-assembly to the brake booster assembly with the 2 nuts.

Torque:
12.5 N*m (127 kgf*cm, 9 ft.*lbf)


c.

Using a 10 mm union nut wrench, connect the 2 brake tubes to the brake master cylinder sub-assembly.

Torque:
15.2 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION



d.

Engage the wire harness clamp.


e.

Connect the brake fluid level warning switch connector.


Hide 31434C 2.INSTALL CLUTCH RESERVOIR TUBE (for Manual Transaxle)

a.

Connect the clutch reservoir tube to the brake master cylinder sub-assembly with the hose clip.


Hide 4.BLEED CLUTCH LINE (for Manual Transaxle)