Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
47570
1.INSTALL REAR WHEEL BRAKE CYLINDER ASSEMBLY
Install the rear wheel brake cylinder assembly to the backing plate with the bolt.
Using a 10 mm union nut wrench, connect the brake tube to the rear wheel brake cylinder assembly.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.INSTALL REAR BRAKE PARKING BRAKE SHOE LEVER SUB-ASSEMBLY
Using needle-nose pliers, install the rear brake parking brake shoe lever sub-assembly to the rear brake shoe (rear) with a new C-washer.
3.INSTALL REAR BRAKE AUTOMATIC ADJUST LEVER
Install the rear brake automatic adjust lever and rear brake automatic adjust lever tension spring to the rear brake shoe (front).
4.INSTALL REAR BRAKE STRUT KIT
Using needle-nose pliers, install the No. 3 parking brake cable assembly to the rear brake parking brake shoe lever sub-assembly.
|
High Temperature Grease |
Apply high temperature grease to the surface of the backing plate that contacts the rear brake shoes as shown in the illustration.
|
High Temperature Grease |
Apply high temperature grease to the adjustment bolt.
Assemble the rear brake strut kit as shown in the illustration.
Install the rear brake strut kit to the rear brake shoe (rear).
Using SST, install the rear brake shoe (rear), shoe hold down spring pin, shoe hold down spring and shoe hold down spring cup.
Install the shoe tension spring to the rear brake shoe (front) and rear brake shoe (rear).
Using SST, install the rear brake shoe (front), shoe hold down spring pin, shoe hold down spring and shoe hold down spring cup.
| *1 | Wheel Cylinder Boot |
| *2 | Tension Spring |
Using SST, install the tension spring to the rear brake shoe (front).
Do not damage the wheel cylinder boot.
| *1 | Backing Plate |
| *2 | Rear Brake Strut Kit |
Inspect the rear brake strut kit is installed properly as shown in the illustration.
5.INSPECT REAR DRUM BRAKE
Inspect that each part is installed properly as shown in the illustration.
| *a | LH Side | *b | RH Side |
|
Front of the Vehicle | - | - |
There should be no oil or grease adhering to the friction surfaces of the shoe lining or the drum.
42403
6.INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
Install the rear brake drum sub-assembly.
7.ADJUST REAR DRUM BRAKE SHOE CLEARANCE
|
Expand |
Temporarily install the 2 wheel nuts.
Turn the adjuster to expand the shoe until the drum locks.
|
Contract |
Hold the rear brake automatic adjust lever away from the adjuster, and contract the rear brake shoe by turning the adjust bolt using another screwdriver until the drum can rotate smoothly.
12 notches
Install the shoe adjusting hole plug.
Remove the 2 wheel nuts.
8.BLEED BRAKE LINE
for LHD
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID(for LHD)>BLEEDING
for RHD
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID(for RHD)>BLEEDING
9.INSTALL REAR WHEEL
10.ADJUST PARKING BRAKE LEVER TRAVEL
58910C
11.INSTALL REAR CONSOLE BOX ASSEMBLY