15100C
1.INSTALL OIL PUMP SEAL
Apply MP grease to the lip of a new oil pump seal.
Keep the lip free of foreign matter.
Using SST and a hammer, tap in the oil pump seal until its surface is flush with the oil pump assembly edge.
0 to -1.0 mm (0 to -0.04 in.)
Do not tap the oil pump seal at an angle.
Wipe off extra grease from the crankshaft.
13407
2.INSTALL CRANKSHAFT DAMPER SUB-ASSEMBLY
12305
3.INSTALL ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH
16361A
4.INSTALL FAN AND GENERATOR V BELT
16361A
5.ADJUST FAN AND GENERATOR V BELT
17410
6.INSTALL FRONT EXHAUST PIPE ASSEMBLY
57533B
7.INSTALL FRONT FLOOR CENTER BRACE
58910C
8.INSTALL REAR CONSOLE BOX ASSEMBLY (w/ Console Box Lid)
58910C
9.INSTALL REAR CONSOLE BOX ASSEMBLY (w/o Console Box Lid)
16361A
10.INSPECT FAN AND GENERATOR V BELT
11.INSPECT FOR ENGINE OIL LEAK
12.INSPECT FOR EXHAUST GAS LEAK
51441C
13.INSTALL ENGINE UNDER COVER RH (w/o Metal Type Under Cover)
51405A
14.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)
51451A
15.INSTALL CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)
16.INSTALL FRONT WHEEL RH