Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING ECU › 2016.04–2016.10
RM30M0E _55 Steering _017103 POWER ASSIST SYSTEMS _0090110 POWER STEERING ECU A

POWER ASSIST SYSTEMS  POWER STEERING ECU  INSTALLATION  


PROCEDURE

Hide 89650 1.INSTALL POWER STEERING ECU ASSEMBLY (for 1NZ-FE, 2NZ-FE)

a.

Install the power steering ECU assembly to the steering column assembly with the 2 nuts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


b.

Connect the 4 connectors.


Hide 89650 2.INSTALL POWER STEERING ECU ASSEMBLY (for 1NR-FE, 2NR-FE)

a.

Install the power steering ECU assembly to the instrument panel reinforcement assembly with the 2 nuts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


b.

Engage the 2 clamps to install the wire harness to the power steering ECU assembly.


c.

Connect the 4 connectors to the power steering ECU assembly.


Hide 55432B 3.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (for 1NR-FE, 2NR-FE)

Hide 55606 4.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 5.PERFORM TORQUE SENSOR ZERO POINT CALIBRATION