Home › Drivetrain › K411 CVT › REVOLUTION SENSOR › from 2016.04
RM30M0E _52 Drivetrain _052750 K411 CVT _0259920 REVOLUTION SENSOR A

K411 CVT  REVOLUTION SENSOR  INSTALLATION  


PROCEDURE

Hide 89413N 1.INSTALL TRANSMISSION REVOLUTION SENSOR (NT)

a.

Clean and degrease the bolt installation hole.


b.

Apply a light coat of Toyota Genuine CVT fluid FE to a new O-ring and install it to the transmission revolution sensor (NT).

NOTICE:

Do not twist the O-ring.



c.

Install the transmission revolution sensor (NT) to the continuously variable transaxle assembly with a new bolt.

NOTICE:

Make sure that the O-ring is not damaged or does not jump out of position during installation.



d.

Connect the transmission revolution sensor (NT) connector.


Hide 89413M 2.INSTALL TRANSMISSION REVOLUTION SENSOR (NOUT)

a.

Apply a light coat of Toyota Genuine CVT fluid FE to a new O-ring and install it to the transmission revolution sensor (NOUT).

NOTICE:

Do not twist the O-ring.



b.

Install the transmission revolution sensor spacer and transmission revolution sensor (NOUT) to the continuously variable transaxle assembly with the bolt.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE:

Make sure that the O-ring is not damaged or does not jump out of position during installation.



c.

Connect the transmission revolution sensor (NOUT) connector.


Hide 89413P 3.INSTALL TRANSMISSION REVOLUTION SENSOR (NIN)

a.

Apply a light coat of Toyota Genuine CVT fluid FE to a new O-ring and install it to the transmission revolution sensor (NIN).

NOTICE:

Do not twist the O-ring.



b.

Install the transmission revolution sensor (NIN) to the continuously variable transaxle assembly with the bolt.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE:

Make sure that the O-ring is not damaged or does not jump out of position during installation.



c.

Connect the transmission revolution sensor (NIN) connector.


Hide 17701 7.INSTALL AIR CLEANER CASE SUB-ASSEMBLY

Hide 17801 8.INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 17880 10.INSTALL AIR CLEANER HOSE ASSEMBLY

Hide 11.INSPECT FOR CONTINUOUSLY VARIABLE TRANSAXLE FLUID LEAK