16326
1.INSTALL NO. 2 WATER INLET HOUSING GASKET
Install a new No. 2 water inlet housing gasket to the water inlet with thermostat sub-assembly.
16321
2.INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
Install the water inlet with thermostat sub-assembly to the timing chain cover assembly with the 3 bolts.
16572D
3.CONNECT NO. 2 RADIATOR HOSE
| *a | View A |
| *b | Top of Vehicle |
| *c | Paint Mark |
Connect the No. 2 radiator hose to the water inlet with thermostat sub-assembly and slide the hose clip to secure it.
Perform the installation with the No. 2 radiator hose and hose clip at the correct angle.
16268
4.CONNECT NO. 1 WATER BY-PASS PIPE
Connect the No. 1 water by-pass hose together with the No. 1 water by-pass pipe to the water inlet with thermostat sub-assembly, and slide the hose clip to secure it.
Install the No. 1 water by-pass pipe to the cylinder block sub-assembly with the bolt.
17168
5.INSTALL NO. 2 EXHAUST MANIFOLD HEAT INSULATOR
27060
6.INSTALL GENERATOR WITH REGULATOR ASSEMBLY
7.ADD ENGINE COOLANT
8.INSPECT FOR COOLANT LEAK