Home › Engine / Hybrid System › 2NR-FE COOLING › THERMOSTAT › from 2016.04
RM30M0E _51 Engine / Hybrid System _053565 2NR-FE COOLING _0259968 THERMOSTAT A

2NR-FE COOLING  THERMOSTAT  INSTALLATION  


PROCEDURE

Hide 16326 1.INSTALL NO. 2 WATER INLET HOUSING GASKET

a.

Install a new No. 2 water inlet housing gasket to the water inlet with thermostat sub-assembly.


Hide 16321 2.INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

a.

Install the water inlet with thermostat sub-assembly to the timing chain cover assembly with the 3 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 16572D 3.CONNECT NO. 2 RADIATOR HOSE

a.
A304826C01
1.74,2.573 2.042,2.302 false 1.583,1.5 1.74,1.698 0.156,0.198 10 false A 0.99,2.281 1.302,2.438 0.313,0.156 10 false *a 1.521,2.24 1.833,2.396 0.313,0.156 10 false *b 2.104,2.208 2.417,2.365 0.313,0.156 10 false *c
*a View A
*b Top of Vehicle
*c Paint Mark


Connect the No. 2 radiator hose to the water inlet with thermostat sub-assembly and slide the hose clip to secure it.

NOTICE:

Perform the installation with the No. 2 radiator hose and hose clip at the correct angle.



Hide 16268 4.CONNECT NO. 1 WATER BY-PASS PIPE

a.

Connect the No. 1 water by-pass hose together with the No. 1 water by-pass pipe to the water inlet with thermostat sub-assembly, and slide the hose clip to secure it.


b.

Install the No. 1 water by-pass pipe to the cylinder block sub-assembly with the bolt.

Torque:
22 N*m (224 kgf*cm, 16 ft.*lbf)


Hide 17168 5.INSTALL NO. 2 EXHAUST MANIFOLD HEAT INSULATOR

Hide 27060 6.INSTALL GENERATOR WITH REGULATOR ASSEMBLY