25051
1.INSTALL EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY
| *1 | Exhaust Manifold Converter Sub-assembly |
| *2 | Exhaust Pipe Gasket |
| *a | Wooden Block |
| *b | Plastic Hammer |
Using a plastic hammer and a wooden block, tap in a new exhaust pipe gasket until its surface is flush with the exhaust manifold converter sub-assembly.
Install the exhaust pipe gasket in the correct direction.
Do not reuse the exhaust pipe gasket.
Do not damage the exhaust pipe gasket by dropping it, etc.
Do not damage the outer surface of the exhaust pipe gasket.
Do not push in the exhaust pipe gasket with the front exhaust pipe assembly when connecting it.
Install a new exhaust manifold to head gasket to the cylinder head sub-assembly.
Temporarily install the exhaust manifold converter sub-assembly to the cylinder head sub-assembly with 5 new nuts.
Tighten the 5 nuts in the order shown in the illustration.
17118
2.INSTALL MANIFOLD STAY
Temporarily install the manifold stay to the exhaust manifold converter sub-assembly and cylinder block sub-assembly with the bolt and a new nut.
Tighten the bolt and nut in the order shown in the illustration.
17410
3.CONNECT FRONT EXHAUST PIPE ASSEMBLY
Using a vernier caliper, measure the free length of the compression spring.
| Standard Length | Minimum Length |
|---|---|
| 42 mm (1.65 in.) | 40.5 mm (1.59 in.) |
If the length is not as specified, replace the compression spring.
| *1 | Exhaust Manifold Converter Sub-assembly |
| *2 | Front Exhaust Pipe Assembly |
| *3 | Exhaust Pipe Gasket |
| *a | Space between flanges: 8.5 mm (0.335 in.) |
Connect the front exhaust pipe sub-assembly to the exhaust manifold converter sub-assembly with the 2 compression springs and 2 bolts.
43 N*m (440 kgf*cm, 32 ft.*lbf)
After the installation, check that the gaps between the flanges of the exhaust manifold converter sub-assembly and front exhaust pipe assembly are consistent front-to-rear and left-to-right.
Engage the clamp to connect the heated oxygen sensor wire to the wire harness clamp bracket.
Connect the heated oxygen sensor connector.
17168
4.INSTALL NO. 2 EXHAUST MANIFOLD HEAT INSULATOR
Install the No. 2 exhaust manifold heat insulator to the exhaust manifold converter sub-assembly with the 3 bolts.
Tighten the 3 bolts in the order shown in the illustration.
89467B
5.INSTALL AIR FUEL RATIO SENSOR
53141F
6.INSTALL RADIATOR COVER
27060
7.INSTALL GENERATOR WITH REGULATOR ASSEMBLY
8.INSPECT FOR EXHAUST GAS LEAK
Perform "Inspection After Repairs" after repairing or replacing the exhaust system.
Click hereEngine / Hybrid System>2NR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION