11101W
1.INSTALL CAMSHAFT POSITION SENSOR (for Intake Side)
Apply a light coat of engine oil to the O-ring.
If reusing the camshaft position sensor, be sure to inspect the O-ring.
Install the camshaft position sensor to the cylinder head cover sub-assembly with the bolt.
If a component has been dropped or subjected to a strong impact, replace the camshaft position sensor.
Make sure that the O-ring is not damaged or does not jump out of position during installation.
Connect the camshaft position sensor connector.
11101W
2.INSTALL CAMSHAFT POSITION SENSOR (for Exhaust Side)
Apply a light coat of engine oil to the O-ring.
If reusing the camshaft position sensor, be sure to inspect the O-ring.
Install the camshaft position sensor to the cylinder head cover sub-assembly with the bolt.
If a component has been dropped or subjected to a strong impact, replace the camshaft position sensor.
Make sure that the O-ring is not damaged or does not jump out of position during installation.
Connect the camshaft position sensor connector.
3.INSPECT FOR ENGINE OIL LEAK
12611
4.INSTALL NO. 1 ENGINE COVER