Home › Engine / Hybrid System › 2NR-FE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR › 2016.04–2017.10
RM30M0E _51 Engine / Hybrid System _053304 2NR-FE ENGINE CONTROL _0260037 CRANKSHAFT POSITION SENSOR A

2NR-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11301K 1.INSTALL CRANKSHAFT POSITION SENSOR

a.
A198002

Apply a light coat of engine oil to the O-ring.

NOTICE:

If reusing the crankshaft position sensor, be sure to inspect the O-ring.



b.

Install the crankshaft position sensor to the timing chain cover assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If a component has been dropped or subjected to a strong impact, replace the crankshaft position sensor.

·

Make sure that the O-ring is not damaged or does not jump out of position during installation.




c.

Connect the crankshaft position sensor connector.


Hide 51441C 3.INSTALL ENGINE UNDER COVER RH (w/o Metal Type Under Cover)

Hide 51405A 4.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)

Hide 51451A 5.INSTALL CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)