Home › Engine / Hybrid System › 1NR-FE ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL › from 2016.04
RM30M0E _51 Engine / Hybrid System _053932 1NR-FE ENGINE MECHANICAL _0262345 REAR CRANKSHAFT OIL SEAL A

1NR-FE ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


CAUTION / NOTICE / HINT

PROCEDURE

Hide 30400 1.REMOVE CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY (for CVT)

Hide 30300 2.REMOVE MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)

Hide 31210 3.REMOVE CLUTCH COVER ASSEMBLY (for Manual Transaxle)

Hide 31250 4.REMOVE CLUTCH DISC ASSEMBLY (for Manual Transaxle)

Hide 32101 5.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for CVT)

a.
A312677E01
1.396,1.917 1.656,1.927 true 1.063,1.844 1.448,2.042 0.385,0.198 10 true SST

Using SST, hold the crankshaft pulley.

SST
09960-10010  (09962-01000, 09963-01000)


b.
A382920

Remove the 8 bolts, rear drive plate spacer, drive plate and ring gear sub-assembly, and front drive plate spacer from the crankshaft.


Hide 13405 6.REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle)

a.
A312677E01
1.396,1.917 1.656,1.927 true 1.063,1.844 1.448,2.042 0.385,0.198 10 true SST

Using SST, hold the crankshaft pulley.

SST
09960-10010  (09962-01000, 09963-01000)


b.
A312678

Remove the 8 bolts and flywheel sub-assembly from the crankshaft.


Hide 11401L 7.REMOVE REAR ENGINE OIL SEAL

a.
A313881C01
1.219,1.156 1.76,1.896 true 3.115,1.344 3.271,1.521 0.156,0.177 10 false *a 1.74,1.917 2.052,2.073 0.313,0.156 10 true *b
*a Cut Position
*b Protective Tape


Using a knife, cut off the lip of the rear engine oil seal.


b.

Using a screwdriver with its tip wrapped with protective tape, pry out the rear engine oil seal from the cylinder block sub-assembly and oil pan sub-assembly.

NOTICE:

After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.