Home › Engine / Hybrid System › 2NR-FE ENGINE MECHANICAL › CYLINDER HEAD GASKET › from 2016.04
RM30M0E _51 Engine / Hybrid System _053933 2NR-FE ENGINE MECHANICAL _0262361 CYLINDER HEAD GASKET A

2NR-FE ENGINE MECHANICAL  CYLINDER HEAD GASKET  REMOVAL  


PROCEDURE

Hide 25051 3.REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY

Hide 23814B 4.REMOVE FUEL DELIVERY PIPE

Hide 23891 5.REMOVE FUEL DELIVERY SPACER

Hide 23291 6.REMOVE INJECTOR VIBRATION INSULATOR

a.
A314476

Remove the 4 injector vibration insulators from the cylinder head sub-assembly.


Hide 16267 7.DISCONNECT NO. 3 WATER BY-PASS HOSE

Hide 16264 8.DISCONNECT NO. 2 WATER BY-PASS HOSE

Hide 22030 9.REMOVE INTAKE MANIFOLD WITH THROTTLE BODY WITH MOTOR ASSEMBLY

Hide 11101 10.REMOVE CYLINDER HEAD SUB-ASSEMBLY

a.
A286216E01
0.438,0.281 0.594,0.479 0.156,0.198 10 3 0.969,0.26 1.125,0.458 0.156,0.198 10 5 1.479,0.271 1.688,0.469 0.208,0.198 10 10 2.063,0.26 2.219,0.458 0.156,0.198 10 8 2.594,0.271 2.75,0.469 0.156,0.198 10 2 2.583,1.844 2.74,2.042 0.156,0.198 10 4 2.073,1.865 2.229,2.063 0.156,0.198 10 6 1.521,1.865 1.677,2.063 0.156,0.198 10 9 0.969,1.865 1.125,2.063 0.156,0.198 10 7 0.448,1.854 0.604,2.052 0.156,0.198 10 1

Using a 10 mm bi-hexagon wrench, uniformly loosen and remove the 10 cylinder head set bolts and 10 plate washers in several steps in the sequence shown in the illustration.

NOTICE:

Removing the cylinder head set bolts in the wrong order may cause warpage or cracking of the cylinder head sub-assembly.



b.

Remove the cylinder head sub-assembly from the cylinder block sub-assembly.


Hide 11115 11.REMOVE CYLINDER HEAD GASKET

a.
A313955

Remove the cylinder head gasket from the cylinder block sub-assembly.


Hide 11101A 12.INSPECT CYLINDER HEAD SET BOLT