11302A
1.INSTALL TIMING CHAIN COVER OIL SEAL
Apply MP grease to the lip of a new timing chain cover oil seal.
Keep the lip free of foreign matter.
Using SST and a hammer, tap in the timing chain cover oil seal until its surface is flush with the timing chain cover sub-assembly.
-0.5 to 1.0 mm (-0.0197 to 0.0394 in.)
Do not tap in the timing chain cover oil seal at an angle.
Wipe off excess grease from the crankshaft.
13471
2.INSTALL CRANKSHAFT PULLEY
| *a | Hold |
| *b | Turn |
Align the pulley set key with the key groove of the crankshaft pulley, then temporarily install the crankshaft and crankshaft pulley bolt to the crankshaft.
Using SST, hold the crankshaft pulley.
Fully tighten the crankshaft pulley bolt.
16361A
3.INSTALL FAN AND GENERATOR V BELT
4.INSPECT FOR ENGINE OIL LEAK
51441C
5.INSTALL ENGINE UNDER COVER RH (w/o Metal Type Under Cover)
51405A
6.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)
51451A
7.INSTALL CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)
8.INSTALL FRONT WHEEL RH