Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR › 2016.04–2017.10
RM30M0E _54 Brake _017098 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0262396 STEERING ANGLE SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  STEERING ANGLE SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 84306 1.INSTALL SPIRAL CABLE SUB-ASSEMBLY

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.

Check that the front wheels are facing straight ahead.


d.

Set the turn signal switch to the neutral position.

NOTICE:

If it is not in the neutral position, the turn signal switch pin may snap.



e.

Engage the 3 claws to install the spiral cable sub-assembly.

NOTICE:

Pull the lock pin out before installing the steering wheel assembly when replacing the spiral cable sub-assembly with a new one.



f.

Connect the connectors to the spiral cable sub-assembly.


Hide 45286B 2.INSTALL UPPER STEERING COLUMN COVER

Hide 45287 3.INSTALL LOWER STEERING COLUMN COVER

Hide 84306 4.ADJUST SPIRAL CABLE SUB-ASSEMBLY

NOTICE:

Do not adjust the spiral cable sub-assembly with the battery connected and the ignition switch to ON.


a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.
B346978C01
2.073,0.677 2.25,0.365 true 2.292,0.26 2.75,0.458 0.458,0.198 10 false (A)
V100144

Colored Part


Check if the spiral cable sub-assembly is centered.

HINT:

When the spiral cable sub-assembly is centered, the part indicated by (A) is positioned at the top and the colored part shown in the illustration is visible.



d.
B346979

If the spiral cable sub-assembly is not centered, center it.

NOTICE:

Do not turn the spiral cable sub-assembly using the airbag wire harness.


i.

Turn the spiral cable sub-assembly counterclockwise until it locks.


ii.
B346980C01
0.729,1.833 0.729,1.167 0.729,1.167 0.813,1.167 true 0.729,1.24 0.813,1.24 false 0.667,1.833 0.979,2.031 0.313,0.198 10 false *a
*a Center Mark
V100144

Colored Part


Rotate the spiral cable sub-assembly clockwise approximately 2.5 turns to the position where the alignment marks are aligned and the colored part shown in the illustration is visible.

NOTICE:

Do not turn the spiral cable sub-assembly using the airbag wire harness.


HINT:

The spiral cable sub-assembly will rotate approximately 2.5 turns to both the left and right from the center.




Hide 45100 5.INSTALL STEERING WHEEL ASSEMBLY

Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)