89661
1.INSTALL ECM (for CVT)
Engage the 3 guides to install the ECM to the ECM bracket.
Install the ECM with ECM bracket to the vehicle with the 2 nuts.
If a component has been dropped or subjected to a strong impact, replace the ECM.
Engage the clamp to connect the wire harness to the ECM bracket.
Connect the 5 ECM connectors.
89661
2.INSTALL ECM (for Manual Transaxle)
Engage the 3 guides to install the ECM to the ECM bracket.
Install the ECM with ECM bracket to the vehicle with the 2 nuts.
If a component has been dropped or subjected to a strong impact, replace the ECM.
Engage the clamp to connect the wire harness to the ECM bracket.
Connect the 4 ECM connectors.
55550
3.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
5. PERFORM INITIALIZATION
Perform "reset memory", "deceleration sensor 0 point calibration", "CVT oil pressure calibration" after replacing the ECM.
Click hereDrivetrain>K312 CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>INITIALIZATION
Perform "Vehicle Identification Number (VIN) or frame number registration" after replacing the ECM.
Click hereEngine / Hybrid System>2NR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION