Home › Engine / Hybrid System › 1NZ-FE COOLING › COOLING FAN MOTOR › 2016.07–2016.10
RM30M0E _51 Engine / Hybrid System _017081 1NZ-FE COOLING _0090205 COOLING FAN MOTOR A

1NZ-FE COOLING  COOLING FAN MOTOR  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Be sure that the ignition switch is off if you work near the electric cooling fans or radiator grille. With the ignition switch ON, the electric cooling fans may automatically start to run if the engine coolant temperature is high and/or the air conditioning is on.


PROCEDURE

Hide 23820 3.DISCONNECT FUEL VAPOR FEED HOSE ASSEMBLY

Hide 23827A 4.DISCONNECT NO. 2 FUEL VAPOR FEED HOSE

Hide 17341T 5.DISCONNECT NO. 1 AIR HOSE

Hide 17735 6.REMOVE AIR CLEANER CAP WITH NO. 1 AIR CLEANER HOSE

Hide 17801 7.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 9.DISCONNECT RADIATOR RESERVOIR TANK HOSE

Hide 10.REMOVE NO. 3 RADIATOR HOSE

a.
A307844

Loosen the 2 hose clips and remove the No. 3 radiator hose from the radiator assembly and water filler sub-assembly.


Hide 16711 11.REMOVE FAN SHROUD

a.
A302947

Disconnect the cooling fan motor connector.


b.

Disengage the 3 clamps to disconnect the wire harness from the fan shroud.


c.
A302894

Disengage the 2 claws and 2 guides to remove the fan shroud from the radiator assembly.

NOTICE:

Do not apply any excessive force to the radiator assembly when removing the fan shroud.



Hide 16361 12.REMOVE FAN

a.
A171259

Remove the nut and fan from the cooling fan motor.


Hide 16363 13.REMOVE COOLING FAN MOTOR

a.
A248174

Remove the 3 screws and cooling fan motor from the fan shroud.