83530
1.INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY
Clean and degrease the threads of the engine oil pressure switch assembly and threaded hole of the cylinder block sub-assembly.
| *a | Adhesive |
Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
To prevent contamination by foreign matter, install immediately after applying adhesive.
| *a | 24 mm Deep Socket Wrench |
Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly to the cylinder block sub-assembly.
Do not start the engine for at least 1 hour after installation.
Connect the engine oil pressure switch assembly connector.
2.INSPECT FOR ENGINE OIL LEAK
51441C
3.INSTALL ENGINE UNDER COVER RH
for Automatic Transaxle:
for Manual Transaxle:
Click hereEngine / Hybrid System>2NZ-FE ENGINE MECHANICAL>ENGINE ASSEMBLY(for Manual Transaxle)>INSTALLATION
51442C
4.INSTALL ENGINE UNDER COVER LH
for Automatic Transaxle:
for Manual Transaxle:
Click hereEngine / Hybrid System>2NZ-FE ENGINE MECHANICAL>ENGINE ASSEMBLY(for Manual Transaxle)>INSTALLATION