1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. (for Hatchback)
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
55661A
3.REMOVE INSTRUMENT PANEL REGISTER BEZEL
55411G
4.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL (for LHD)
55411G
5.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL (for RHD)
83100
6.REMOVE COMBINATION METER ASSEMBLY
| *a | Protective Cover |
Cover the upper steering column cover with the protective cover (a piece of cloth or nylon).
Remove the 2 screws.
Disengage the 2 clips and 2 guides to separate the combination meter assembly.
Disconnect the 2 connectors to remove the combination meter assembly.