Home › Vehicle Interior › METER / GAUGE / DISPLAY › COMBINATION METER(for TMMIN Made) › 2017.10–2018.01
RM30M0E _58 Vehicle Interior _017113 METER / GAUGE / DISPLAY _0333138 COMBINATION METER(for TMMIN Made) A

METER / GAUGE / DISPLAY  COMBINATION METER(for TMMIN Made)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 55412D 3.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL (w/ Radio Receiver)

Hide 55412D 4.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL (w/o Radio Receiver)

Hide 45287 5.REMOVE LOWER STEERING COLUMN COVER

Hide 45286B 6.REMOVE UPPER STEERING COLUMN COVER

Hide 55411G 7.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL

Hide 8.REMOVE UPPER CENTER INSTRUMENT CLUSTER FINISH PANEL

Hide 55474C 9.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55650 10.REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55410C 11.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 83100 12.REMOVE COMBINATION METER ASSEMBLY

a.
E281108

Remove the 3 screws.


b.

Disengage the 2 guides.


c.
E281109

Disconnect the 2 connectors and remove the combination meter assembly.