55349C
1.INSTALL INSTRUMENT PANEL CUSHION
Using a piece of cloth, rub the remaining double-sided tape off the instrument panel.
Installing the instrument panel cushion with any double-sided tape remaining on the instrument panel may cause adhesion failure.
Using a non-residue solvent, clean the attachment surface.
Install a new instrument panel cushion onto the instrument panel.
55356C
2.INSTALL NO. 2 INSTRUMENT PANEL CUSHION
|
Adhesive Portion |
Align the markings on the instrument panel with a new No. 2 instrument panel cushion and install the No. 2 instrument panel cushion using hot-melt glue or double-sided tape.
55355
3.INSTALL NO. 1 INSTRUMENT PANEL CUSHION
|
Adhesive Portion |
Align the markings on the instrument panel with a new No. 1 instrument panel cushion and install the No. 1 instrument panel cushion using hot-melt glue or double-sided tape.
82142
4.INSTALL NO. 2 INSTRUMENT PANEL WIRE (for Automatic Air Conditioning System)
Engage the 3 clamps and install the No. 2 instrument panel wire.
55845A
5.INSTALL NO. 3 HEATER TO REGISTER DUCT
Engage the 2 guides and install the No. 3 heater to register duct.
Install the 2 screws <C>.
86101
6.INSTALL ANTENNA CORD SUB-ASSEMBLY
55084E
7.INSTALL NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY
Engage the 3 guides and install the No. 1 heater to register duct sub-assembly.
Install the 3 screws <C>.
73970A
8.INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
55085
9.INSTALL NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY
Engage the 3 guides and install the No. 2 heater to register duct sub-assembly.
Install the 3 screws <C>.
55950G
10.INSTALL DEFROSTER NOZZLE ASSEMBLY
Engage the 3 guides and install the defroster nozzle assembly.
Install the 3 screws <C>.
55318C
11.INSTALL INSTRUMENT SIDE PANEL LH
Engage the 5 claws and the 3 guides and install the instrument side panel LH.
55317A
12.INSTALL INSTRUMENT SIDE PANEL RH
Use the same procedure as for the LH side.
55627A
13.INSTALL INSTRUMENT PANEL CUP HOLDER RAIL (for Front Passenger Side)
Engage the 2 guides and install the instrument panel cup holder rail.
Install the 3 screws <C>.
55627A
14.INSTALL INSTRUMENT PANEL CUP HOLDER RAIL (for Driver Side)
Engage the 2 guides and install the instrument panel cup holder rail.
Install the 3 screws <C>.
55434F
15.INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL
Engage the 5 claws and install the lower center instrument panel finish panel.
55434B
16.INSTALL NO. 2 LOWER CENTER INSTRUMENT PANEL FINISH PANEL
Engage the 2 claws and the 2 clips and install the No. 2 lower center instrument panel finish panel.
88625H
17.INSTALL COOLER (SOLAR SENSOR) THERMISTOR (for Automatic Air Conditioning System)
88625Q
18.INSTALL COOLER (ROOM TEMPERATURE SENSOR) THERMISTOR (for Automatic Air Conditioning System)