Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
82142A
1.INSTALL INSTRUMENT PANEL WIRE ASSEMBLY
| *1 | Locking Button |
Connect the airbag connector of the instrument panel wire assembly to the instrument panel passenger airbag assembly.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Push in the locking button to install the airbag connector to the instrument panel passenger airbag assembly.
Securely lock the locking button.
73970A
2.INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
Engage the 12 claws to install the instrument panel passenger airbag assembly.
Install the 2 nuts.
55085
3.INSTALL NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY
55950G
4.INSTALL DEFROSTER NOZZLE ASSEMBLY
88625H
5.INSTALL COOLER (SOLAR SENSOR) THERMISTOR (for Automatic Air Conditioning System)
55301
6.INSTALL INSTRUMENT PANEL SUB-ASSEMBLY (for Manual Air Conditioning System)
7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
8.INSPECT SRS WARNING LIGHT