Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › 2017.10–2018.01
RM30M0E _51 Engine / Hybrid System _052909 CRUISE CONTROL _0256264 CRUISE CONTROL SYSTEM J

CRUISE CONTROL  CRUISE CONTROL SYSTEM  Cruise SET Indicator Light Circuit  


DESCRIPTION

·

The ECM turns on the SET indicator by sending indicator output demand signals to the combination meter assembly using CAN communication.

·

The cruise control SET indicator illuminates when the cruise control system is controlling vehicle speed.

·

The cruise control indicator circuit uses CAN communication. If the cruise control indicator is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.


PROCEDURE

1.CONFIRM MODEL (CHECK COMBINATION METER ASSEMBLY)
Result:
Result Proceed to
for TFT Display Type A
for Segment Display Type B



A

2.PERFORM ACTIVE TEST USING GTS

B

3.PERFORM ACTIVE TEST USING GTS
2.PERFORM ACTIVE TEST USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

Check the cruise control SET indicator by performing the Active Test.

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Meter Display 1 Multi-information display OFF, 6 to 0 or All -
Meter Display 2 Multi-information display OFF, 9 to 7 -
Body Electrical > Combination Meter > Active Test
Tester Display
Meter Display 1
50004 122 7
Body Electrical > Combination Meter > Active Test
Tester Display
Meter Display 2
50004 122 8
OK:

The multi-information display in the combination meter assembly turns off or completely on according to the GTS operation.



Result:
Result Proceed to
OK A
NG B



A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

3.PERFORM ACTIVE TEST USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

Check the cruise control SET indicator by performing the Active Test.

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Indicat. SET Cruise control SET indicator Cruise control SET indicator ON / OFF -
Body Electrical > Combination Meter > Active Test
Tester Display
Indicat. SET
50004 122 91
OK:

The cruise control SET indicator goes on or goes off.



Result:
Result Proceed to
OK A
NG (for TMT Made) B
NG (for TMMIN Made) C



A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

C