The combination meter assembly detects the condition of the parking brake switch.
Check the operation of the parking brake warning light.
Parking brake warning light operates normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the parking brake switch assembly.
Inspect the parking brake switch assembly.
Click hereBrake>PARKING BRAKE>PARKING BRAKE SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the F14 parking brake switch assembly connector.
Disconnect the F38 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F14-1 - F38-16 (PKBI) | Always | Below 1 Ω |
| F14-1 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG