Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
1.REMOVE FRONT WHEEL
53876A
2.REMOVE FRONT FENDER LINER
for TMMIN Made:
| *1 | Pin Hold Clip |
| *a | 90° |
Using a screwdriver, turn the pin 90° and remove the pin hold clip.
Remove the 7 clips, 3 screws, 4 grommets and the front fender liner from the body.
for TMT Made:
| *a | Protective Tape |
Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws to remove the pin hold clip from the front fender liner retainer.
Remove the 7 clips, 3 screws, 4 grommets and the front fender liner from the body.
3.SEPARATE FRONT SPEED SENSOR WIRE
Disconnect the front speed sensor connector.
Disengage the 2 clamps from the body.
Disengage the 3 clamps.
Remove the 2 bolts and separate the front speed sensor wire and front flexible hose from the body and front shock absorber assembly.
43502H
4.REMOVE FRONT AXLE SHAFT NUT
5.SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY
43512
6.REMOVE FRONT DISC
Click hereBrake>BRAKE (FRONT)>FRONT BRAKE>REMOVAL
43502C
7.REMOVE FRONT AXLE HUB SUB-ASSEMBLY
| *a | Matchmark |
Put matchmarks on the front drive shaft assembly and front axle hub sub-assembly.
Using a plastic hammer, tap the end of the front drive shaft assembly and separate the fitting between the front drive shaft assembly and front axle hub sub-assembly.
Be careful not to damage the thread portion of the front drive shaft assembly.
If it is difficult to separate the front drive shaft assembly from the front axle hub sub-assembly, tap the end of the front drive shaft assembly using a brass bar and a hammer.
Remove the 3 bolts, front axle hub sub-assembly and front disc brake dust cover from the steering knuckle.
Do not place the front speed sensor side so that it is facing downward, and do not allow the front speed sensor side to become damaged or contact foreign matter.
Do not drop the front axle hub sub-assembly.
Be careful not to damage the drive shaft boot.
The front axle hub sub-assembly is a component of the front speed sensor.