55606
1.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for TMMIN Made)
55432B
2.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (for TMMIN Made)
55411G
3.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL (for TMMIN Made)
55302A
4.REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY (for TMT Made)
84340
5.REMOVE STOP LIGHT SWITCH ASSEMBLY
84345
6.REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER
Remove the stop light switch mounting adjuster from the brake pedal support sub-assembly.
7.SEPARATE WIRE HARNESS
Disengage the 2 wire harness clamps.
Disconnect the accelerator pedal sensor assembly connector.
47101A
8.REMOVE BRAKE PEDAL RETURN SPRING
Remove the brake pedal return spring from the brake pedal support sub-assembly and push rod pin.
47264D
9.SEPARATE BRAKE MASTER CYLINDER PUSH ROD CLEVIS
Remove the clip and push rod pin to separate the brake master cylinder push rod clevis from the brake pedal sub-assembly.
55106
10.REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY
| *A | for TMMIN Made |
| *B | for TMT Made |
Remove the bolt to separate the brake pedal support sub-assembly from the instrument panel reinforcement.
Remove the 4 nuts and brake pedal support sub-assembly from the body.